PED5-X12-H Instructions

INSTALLING IPHONE (device):

A one-time adjustment of the sliding finger grips is all that is needed to size the holder to a bare or cased device.  After proper adjustment, you'll be able to quickly and easily place the device in and out of the holder from the natural flexibility of the holder body.  Using the 5/64" wrench*, loosen the four screws by turning counter-clockwise so that they slide in and out.  Place and center the device into the holder and slide the fingers toward the device to a snug fit so that the device is secure and will not fall out when turned upside down (a properly fitted holder will hold a device even when held upside down).  When adjusting the fingers for your iPhone, make sure that the right and left fingers are evenly aligned when secured in their final position. This will ensure better performance while using the product.  Using the 5/64" wrench*, lightly tighten the four screws by turning clockwise.  Minor adjustments may be needed to achieve a snug fit.

Attach the extended tripod mount to any compatible camera or tripod mount that has a male 1/4"-20 thread and position to your desired position.

BALL SOCKET - Friction Screw Adjustment:

The design of the ball socket is intended to be able to move relatively freely with little to some effort, it is NOT possible to LOCK the ball socket using the friction adjustment screw and should not be attempted.

Overtime you may experience the ball socket does not have the holding power it had when it was new.  If this occurs, with the iPhone removed from the PED5 holder, using the supplied 3/32" wrench*, in the center hole, turn the recessed screw clockwise until the desired holding power is achieved.