Finger Instructions

INSTRUCTIONS FOR ADJUSTING HOLDERS WITH EXISTING FINGERS IN PLACE (NEW PRODUCTS):
Do not remove the finger from the holder, only do so if necessary, for instance due to replacement installation (see below for instructions on installing fingers).

Using the limiting torque 5/64" wrench* (small tool) provided with your holder, it is important to not over torque the finger. While looking at the screw it is important to LOOSEN the screw only a quarter of a turn COUNTER CLOCKWISE, make your adjustment by sliding the finger in the slot, and then using the supplied wrench, turn the screw CLOCKWISE LIGHTLY to TIGHTEN. The amount of torque to hold the finger in place is very minimal.

INSTRUCTIONS FOR INSTALLING FINGERS:
With the finger removed, place the new finger in the slot with the screw removed, and hold in place with your finger in one hand. With your opposite hand, roughly place the screw in the slot on the opposite side of the finger. It does not have to be in the screw hole yet, grab with your opposite hand the limiting torque 5/64" wrench* (small tool) and match up to the screw head. From here it should be very easy to find the screw hole while turning the wrench CLOCKWISE and LIGHTLY TIGHTEN with the finger in the closed position. Now complete as necessary in other locations. Once all fingers are replaced, you can then move on to the next procedure of configuring it to your bare or cased device.

CONFIGURING TO YOUR BARE OR CASED DEVICE:

While looking at the screw it is important to LOOSEN the screw only a quarter of a turn COUNTER CLOCKWISE, make your adjustment by sliding the finger in the slot, and then using the supplied wrench, turn the screw CLOCKWISE LIGHTLY to TIGHTEN. The amount of torque to hold the finger in place is very minimal.